Gallery

  • Close-up of the hull of a white boat on a boat stand, with metal supports and a dark background. shows GTD marine skin fittings for SideJets

    Starboard skin fitting on the test boat

  • View of a GTD marine sideJets skin fitting from above with hoses and metal fittings inside an open white compartment with a gray inner lining.

    View down into the starboard locker

  • A close-up view of the bow of a black and white motorboat on greenish water maneuvering using Marine SideJets from GTD Marine, showing the hull and reflection in the water.

    Powerful jet, minimal noise and disturbance

  • GTD Marine SideJets Battery bank with multiple batteries connected with red and black cables inside a metallic enclosure.

    Battery bank and port side hose run

  • Close-up of the GTD Marine SidePod stern thruster and outboard propeller of a boat, with some black and silver components and a red cloth tied to a rod, on gravel ground and brick pavement.

    No drilling required, just clamp and thrust

  • This image shows the interior of a boat, focusing on the engine and surrounding components. The engine appears to be a Volvo Penta, with wires and parts connected. The area is clean and organized, with the boat's hull and some outdoor elements visible at the bottom.

    View of the through skin gland offsetting the cable run

  • A Volvo Penta outdrive with a stern thruster mounted on the cavitation plate, a GTD marine rock solid clamp on SidePod, no drilling of holes required.

    SidePod 30 with bidirectional prop (also available in black)

  • Close-up of a boat's outboard motor with a stern thruster mounted on the cavitation plate, a GTD marine rock solid clamp on SidePod, no drilling of holes required.

    SidePod 30 clamped to a lovely Mercury 200, no drilling

  • Underneath view of a boat's hull on a trailer, showing a hole where a GTD Marine skin fitting is being installed, ready for a GTD Marine SideJets thruster.

    Installing the skin fittings in the bow ready for the SideJets

  • Close-up of a boat hull with a circular opening, a GTD Marine 316 stainless steel skin fitting for a SideJets thruster.

    Another beautiful finish. Strong and low drag

  • Close-up of the motor and propeller of a boat's Mercury Bravo Three outdrive with a stern thruster mounted on the cavitation plate, a GTD marine rock solid clamp on SidePod, no drilling of holes required.

    SidePod 40 installation on a Mercury Bravo Three

  • Outboard motor (Mercury Bravo Three) attached to the stern of a boat, A Mercury Bravo Three outdrive with a stern thruster mounted on the cavitation plate, a GTD marine rock solid clamp on SidePod, no drilling of holes required.

    SidePod with rock solid GTD clamp mounting, no holes!

  • A boat's Mercury Bravo Three outdrive with a stern thruster mounted on the cavitation plate, a GTD marine rock solid clamp on SidePod thruster.

    SP40 sitting pretty with the drive trimmed up

  • SideJets unit showing the left-hand end

  • SideJets unit showing the right-hand end